Messa in fase Ape 550

Quesiti tecnici riguardanti l'Ape anni '50, '60 e '70 (telai A, B, C, D, E, MP) / Technical questions about Ape in the fifties, sixties and seventies (A, B, C, D, E, MP chassis).
Avatar utente
Volantepazzo
Apista esperto
Apista esperto
Messaggi: 201
Iscritto il: 11 aprile 2012, 14:25
Ape owned: MPA1
Località: Caserta

Re: Messa in fase Ape 550

Messaggio da Volantepazzo »

Put in the motor at the top dead center with a 5 rod in the hole I had to rotate the whole slide to allow the pins to open by turning on the bulb :((
Avatar utente
kjjohnson
1° Apista restauratore
1° Apista restauratore
Messaggi: 6138
Iscritto il: 3 dicembre 2007, 11:17
Ape owned: MPR2
Località: Bayfield, Ontario, Canada
Contatta:

Re: Messa in fase Ape 550

Messaggio da kjjohnson »

After setting TDC the distributor is mounted with the points just about to open. Think you need to turn the drive slot 180 degrees as you may have set it where points are just beginning to close. Remember rotation of the fan. Ken ^&$
we buy/restore/sell P501 and P601s and parts/manuals/handbooks
http://www.kjjohnson.ca/
Rispondi