Mondoape.com

Hi Everyone
I am looking for an igniton switch to suit my AD1T it has 9 connections on the back anyone got a spare they want to sell
Many Thanks
Mal

Hi Everyone I have come to reconnect the wiring loom on my AD1 and I seem to have the Bianco (White) wire missing that connects No.5 terminal on the Gruppo Raddrizzatore (Rectifier) to the No.2 terminal on the ignition switch. Can anyone tell me what the function of this wire is ?, the engine will s...

what is the cost
Thanks
Mal

Hi everyone
I am looking for a locking exterior door handle to suit my AD1 has anyone got a spare they would sell
Many Thanks
Mal

Hi Everyone
I need a kickstart quadrant and shaft for my AD1M engine, has anyone got one to sell are they interchangeable with any of the early vespa engines. I would also consider converting it to an electric start if anyone has the parts
Thanks
Mal

Hi mondoape
Many thanks for that when I undone the nut there was no snap ring in the cooling fan, so I will have to reassemble and insert a snap ring
Thanks again
Mal

Hi Everyone
Can anyone tell me how to remove the cooling fan an my AD! engine, do I need a special puller ? and can this be done whilst still in the car
Many Thanks
Mal

Hi There
If you are breaking for spares have you got a fuel tap and the aluminium floor plate that fits between the two floors
Many thanks
Mal

Hi
Would you know the lengths of these cables as I do not have any originals to measure
Many Thanks
Mal

Hi All
To complete my restoration of the AD! I need information on the relevant part numbers for the folloeing
Handbrake Cable
Clutch Cable
Throttle Cable
Gear Change Cables
Are they still available to purchase , or do I have to make them
Many Thanks
Mal

Excellent
Many Thanks again
Mal

Hi There agian
Has anyone got a schematic wiring diagram for the AD1 showing the relevant wire colours that go to each component. I have the one that shows the layout but not where each coloured wire fits
Many Thanks
Mal

Hi Everyone
I am after the nut that holds the rear bearing in place in the hub (part No 15 ) the one that is threaded and has 4 holes drilled into it for the spanner, I need the Left hand threaded one are these available any where or will I have tohave them made
can anyone help
Thanks
Mal

Hi
Thanks for that information you would know better than me has this is my first encounter with apes, so does anybody know what bits I am missing then
Many Thanks
Mal

Hi
My window is different from your photograph, My window has two pegs the bottom peg is threaded and the top one is not, the door has a hole in the channel where the threaded peg fits, but how does the top peg fit?
Thanks
Mal