Mondoape.com

On the electronic coil do you know what the 3 coloured wires are? I have a whit black and red

Thanks

I've ordered one should be on its way. Again wish I found your site earlier in the build.

Thanks again Ken I cut the pedal box in this morning fits perfect! Hope you don't mind I have a couple more questions? I'm trying to fit the carb to the engine I have ordered one of these below but the carb still hits the cylinder head, do I need an extension piece? http://www.ebay.co.uk/itm ...

Had a go last night fitting up the cylinder head, everything fits perfectly and is all built up nicely! Next phase is getting the carb all built up with cables and controls ready to start her up. If you don't mind taking some pictures of the pedals from above and below that would be a great help ...

Thanks Ken any pictures would be great!

The gudgeon is definitely a 23mm, the bearing turned up from Italy and fits perfect. Did they use different sizes?

https://www.flickr.com/photos/106494192 ... /lightbox/ my ape pictures so far

It seems to be a 23mm pin? Do you or could you take a picture of the peddles from inside the cab and underneath. Mine has a new floor and I don't know how and where to mount the peddles and where to cut the holes.

Any help would be great

I would have preferred to order all the parts i needed from one place, I will start to use your site for the rest of the bits! Do you know roughly shipping costs to the UK?

I measured the gudegon pin at 23mm but will remeasure and check.

Just used your website, to look up the chassis number it is a 1979 p601v 190cc engine. Will the carb i order be correct?

By the way your website is a fantastic resource!

Unfortunately when we bought the 601 we didn't have either the cylinder or carb, so not sure what was in it. I do have the engine number and chassis if this would help? I will not quote the full numbers just in case. MPMM13** engine MPV1T229** chassis DGM 72**OM The carb i have purchased is this one ...

Thank you Ken! I was going a little mad trying to find a none existent o ring to fit the top hat! I have bought a standard carb for the p601, I know it will need upjetting but do you have any idea what size i would need? or do you recommend buying another carb? or should i just buy an original 190cc ...

Hello, I am from the UK and have just bought a Vespacar p601v. The piaggio doesn't have a cylinder head so i have bought this one from sip-scooters http://www.sip-scootershop.com/en/products/racing+cylinder+polini+225cc+_14000850. My question is? Do you know if their is a gasket between the cylinder ...